| GENERAL MAINTENANCE
The Flexible Furler requires no maintenance to keep the warranty in force;
however, it is always good to keep the system clean. Usually, dousing
the drum with fresh water every 5 years is adequate. If you have a ball
bearing installed, we recommend lifting the drum and being a little more
purposeful in cleaning the bearing. This is a 5 minute procedure.
STORAGE The luff extrusion
is best stored straight, perhaps strapped alongside the mast. All but
the FF9.0 can be coiled in large coils, but if left in that position
for prolonged periods, the luff may take a set that will have to be
removed by coiling the luff in the opposite direction. |
||||
 |
Removing luff support pin. |
 |
Lifting spool to clean bearing. |
|